SOG Type 320S Saneo venting system Roof variant

An end to odor

By means of a small high-performance ventilator (resistant to the aggressive components in the intake air from the holding tank | watertight) specially developed for and with SOG, the following effect is achieved

• switches on automatically when the toilet slide is opened and creates a negative pressure in the waste-holding tank
• this creates a SOG at the slider opening, which draws in fresh air and also the odors produced during use and directs them outside
• the drawing in of the air acts as a seal and prevents 100% of all unpleasant foul gases from rising from the tank (comfort without odor)
• However, after automatic switch-off, there is still ventilation to the outside and a closed system to the inside.

Environmental protection

In addition to putting an end to odor nuisance, active toilet ventilation has the great advantage that it does not require the use of any chemicals at all. When the valve is closed, the SOG system's hose connection to the outside ensures that the decomposition process is accelerated by the deliberate supply of oxygen to the waste-holding tank. Even commercially available toilet paper is decomposed in a very short time and the use of special paper is unnecessary.

Roof variant

In this version, the holding tank is connected to a roof duct via a pipe. The high-performance ventilator is located directly under the roof duct and ensures sufficient negative pressure in the pipe section of up to three meters. The gas-tight sanitary hose available in motorhome accessories has proven to be the easiest to install when retrofitting a roof vent. The parts supplied are matched to a wastewater pipe system available from camping supply stores. The roof vent is maintenance free as no filter is required. Retrofitting is often quite costly, which is why it is mainly used by manufacturers as original equipment.

Contents of the complete kit

• Fan motor integrated in housing
• Exhaust hose with connector
• Adapter parts for connection to the cassette
• Closing plug (for use when emptying the cassette)
• Set of cables with switch for power supply of the fan (during use)
• complete small parts for assembly
• Assembly instructions (very differentiated)
• Roof duct with chimney (not included are the required waste water pipes from the fan to the roof duct | matched to waste water pipe system available in camping stores)