Büttner Elektronik MT Flat Light Q complete solar system

This direct stick-on solar module is ideally suited for pop-up or high roofs of CamperVans, for the panel van and camping bus or as a walk-on version on the motorhome roof. The Q-module, like all Flat Light modules, combines high quality workmanship and maximum solar power. The square design allows high charging power even in very limited space. Thus it is possible to operate a compressor refrigerator and/or an inverter self-sufficiently. When mounted on high roofs, the connection cable can be routed centrally downwards within the solar module. However, an ultra-flat roof bushing is also included. The connection centrally downwards is possible.

Tips and Info

Solar modules for direct adhesion!
The ultra-flat Flat Light Q solar modules are also particularly suitable for direct bonding to motorhome roofs. These modules are the alternative to the previously presented standard solar modules with housing frames, especially where a low installation height or the accessibility of the solar modules is required.

Due to the very high quality surface, these solar modules are optimally protected from the weather. The junction box is also a design that has been tried and tested in the marine sector for many years. We have done everything that is technically possible for these modules and have implemented our high quality standards here as well. This also applies to the cell connectors. These are specially designed for this purpose
designed to be able to compensate for high temperature differences.

Pressure-tight roof duct
High demands should also be made on the roof feed-through. If moisture penetrates, experience shows that the damage is not detected until it is far too late, and any mold growth is not without health risks. Not to mention the financial damage. For this reason, we have developed a bushing made of the same PU rigid foam as our holding profiles and their cable bushing, which have been tried and tested for 20 years. Like the Flat Light solar modules, this is also bonded with Sikaflex, a high-strength industrial adhesive sealant. In our opinion, no compromises should be made on this point either.

Further details

• Modules walkable
  • Solar modules can be walked on when glued to the surface.
• Low weight
  • With the same power, weight advantages compared to other solar systems of the same power.
• Specially developed for touring vehicles
  • Solar modules for mobile homes and caravans are subjected to different stresses than those for domestic systems! For example, for mobile use the junction boxes must be pressurized water-tight (driving wind) and the soldered connections must be specially designed for the vibrations that occur. The frame construction also requires a special design to compensate for any torsion and uplift forces that may occur.

Scope of delivery

Ultra strong roof grommet
High strength roof grommet specially designed for Flat Light solar panel
Walkable and absolutely water pressure-tight up to 10 bar. Absolutely watertight cable gland. Included with every Flat Light solar module.