Victron BlueSolar MPPT 75/10 Solar charge controller 75V / 10 AVictron BlueSolar MPPT 75/15 Solar charge controller 75 V / 15 AVictron BlueSolar MPPT 100/15 Solar charge controller 100 V / 15 AVictron BlueSolar MPPT 150/35 Charge charge controller 150 V / 35 A
Availability:
Available in 3-5 working days
Availability:
Available in 3-5 working days
Availability:
Available in 3-5 working days
Only small number of pieces available
Availability:
Available in 3-5 working days
Only small number of pieces available
Product details
Battery Life: intelligent battery management | Programmable battery charging algorithm |
Product description
Ultra Fast Maximum Power Point Tracking (MPPT)
Especially under cloudy skies, when light intensity is constantly changing, an extremely fast MPPT controller improves the energy yield by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers
Load output
A too deep discharge of the battery can be prevented by connecting all loads to the load output. The load output disconnects the loads when the battery has been discharged to a specified voltage value. Alternatively, an algorithm for intelligent battery management can be selected: see Battery Life. The load output is short circuit proof. Some loads (especially inverters) are best connected directly to the battery. The inverter remote control is best connected to the load output. A special interface cable may be required, please refer to the manual
Battery Life: intelligent battery management
If the solar charge controller is not able to charge the battery to its full capacity within one day, the status of the battery constantly changes between "partially charged" and "end of discharge". This operating mode (no regular full charging) will damage a lead-acid battery within a few weeks or months. The Battery Life Algorithm monitors the battery's state of charge and, if necessary, it raises the load disconnect threshold (i.e. load is disconnected earlier) on a daily basis until the energy gained is sufficient to charge the battery to near 100%. At this point, the threshold for disconnecting the load is modulated so that near 100% charging is achieved approximately once a week
Programmable battery charging algorithm
For more information, please refer to the Software section on our website
Day/night time control and light insulation option
For more information, please refer to the Software section on our website
Programming options, real-time data and history display
- ColorControl GX or other GX units: Please refer to the Venus documents on our website.
- For a Smartphone or other Bluetooth enabled device: A VE.Direct Bluetooth Smart Dongle is required
Especially under cloudy skies, when light intensity is constantly changing, an extremely fast MPPT controller improves the energy yield by up to 30% compared to PWM charge controllers and by up to 10% compared to slower MPPT controllers
Load output
A too deep discharge of the battery can be prevented by connecting all loads to the load output. The load output disconnects the loads when the battery has been discharged to a specified voltage value. Alternatively, an algorithm for intelligent battery management can be selected: see Battery Life. The load output is short circuit proof. Some loads (especially inverters) are best connected directly to the battery. The inverter remote control is best connected to the load output. A special interface cable may be required, please refer to the manual
Battery Life: intelligent battery management
If the solar charge controller is not able to charge the battery to its full capacity within one day, the status of the battery constantly changes between "partially charged" and "end of discharge". This operating mode (no regular full charging) will damage a lead-acid battery within a few weeks or months. The Battery Life Algorithm monitors the battery's state of charge and, if necessary, it raises the load disconnect threshold (i.e. load is disconnected earlier) on a daily basis until the energy gained is sufficient to charge the battery to near 100%. At this point, the threshold for disconnecting the load is modulated so that near 100% charging is achieved approximately once a week
Programmable battery charging algorithm
For more information, please refer to the Software section on our website
Day/night time control and light insulation option
For more information, please refer to the Software section on our website
Programming options, real-time data and history display
- ColorControl GX or other GX units: Please refer to the Venus documents on our website.
- For a Smartphone or other Bluetooth enabled device: A VE.Direct Bluetooth Smart Dongle is required
MPPT 75/10 | MPPT 75/15 | MPPT 100/15 | MPPT 150 / 35 | |
Battery voltage | 12/24V | 12/24V | 12/24V | 12/24/48V |
Rated charging current | 10 A | 15 A | 15 A | 35 A |
Nominal PV power, 12 V 1a,b) | 145 W | 220 W | 220 W | 500 W |
Nominal PV power, 24V 1a,b) | 290 W | 440 W | 440 W | 1000 W |
Maximum PV open circuit voltage | 75 V | 75 V | 100 V | 150 V |
Max. Short circuit current of the solar system 2) | 13 A | 15 A | 15A | 40 A |
Max. Efficiency | 98 % | 98 % | 98 % | 98 % |
Automatic load disconnection | Yes | Yes | Yes | Yes |
Own consumption | 12V: 25 mA 24V: 15 mA |
12V: 25 mA 24V: 15 mA |
12V: 25 mA 24V: 15 mA |
12V: 20 mA 24V: 15 mA 48V: 10 mA |
"Constant" charging voltage (absorption) | 14.4 V / 28.8 V | 14.4 V / 28.8 V | 14.4 V / 28.8 V | 14.4 V / 28.8 V / 43.2 V / 55.2 V |
"Float" charging voltage (absorption) | 13.8V / 27.6V | 13.8V / 27.6V | 13.8V / 27.6V | 13.8V / 27.6V / 41.4V / 55.2V |
Charge algorithm | multistage, adaptive | multistage, adaptive | multistage, adaptive | multistage, adaptive |
Temperature compensation | -16 mV/°C or -32 mV/°C | -16 mV/°C or -32 mV/°C | -16 mV/°C or -32 mV/°C | -16 mV/°C / -32 mV/°C / -64 mV/°C |
Uninterruptible/load current | 15A | 15A | 15A | 15A |
Protection | Output short circuit / overheating | Output short circuit / overheating | Output short circuit / overheating | Output short circuit / overheating |
Operating temperature | -30 °C to +60 °C | -30 °C to +60 °C | -30 °C to +60 °C | -30 °C to +60 °C |
Humidity | 95 % | 95 % | 95 % | 95 % |
Data communication port | VE.Direct | VE.Direct | VE.Direct | VE.Direct |
Power connections | 6mm²/AWG10 | 6mm²/AWG10 | 6mm²/AWG10 | 6mm²/AWG10 |
Features
Type of solar panel | Solar accessories |
Design | MPPT 75/10 |
Weight | 0,5 kg |
Dimensions (LxWxH) | 40 x 113 x 100 m |
ean | 8719076025306 |
Manufacturer Article No. | SCC010010050R |
Features
Type of solar panel | Solar accessories |
Design | MPPT 75/15 |
Weight | 0,5 kg |
Dimensions (LxWxH) | 40 x 113 x 100 mm |
ean | 8719076025320 |
Manufacturer Article No. | SCC010015050R |
Features
Type of solar panel | Solar accessories |
Design | MPPT 100/15 |
Weight | 0,6 kg |
Dimensions (LxWxH) | 50 x 113 x 100 mm |
ean | 8719076025337 |
Manufacturer Article No. | SCC010015200R |
Features
Type of solar panel | Solar accessories |
Design | MPPT 150/35 |
Dimensions (LxWxH) | 7 x 18,6 x 13 cm |
ean | 8719076025559 |
Manufacturer Article No. | SCC020035000 |
Legal information
Manufacturer information
Accusysteme TransWatt GmbH
Am Tiggemann 4
59505 Bad Sassendorf
Germany
matyschik@transwatt.de
Legal information
Manufacturer information
Accusysteme TransWatt GmbH
Am Tiggemann 4
59505 Bad Sassendorf
Germany
matyschik@transwatt.de
Legal information
Manufacturer information
Accusysteme TransWatt GmbH
Am Tiggemann 4
59505 Bad Sassendorf
Germany
matyschik@transwatt.de
Legal information
Manufacturer information
Accusysteme TransWatt GmbH
Am Tiggemann 4
59505 Bad Sassendorf
Germany
matyschik@transwatt.de